dgordon.68443
2006-10-04, 06:22 PM
Does any notice with their surfaces whether performing edits to the surface is very memory intensive. For example if I perform the swap edges command, and when I'm finished swaping edges, even though the contours had moved while I was doing this, that it would take quite a long time after finishing the command before I could go on to another type of edit like delete lines. Has this been improved in 2007? With a question like this, your probably thinking what speed is your computer. What video card? etc...
Well I'm using a 3.0 ghz computer with 1 gig of ram and a nvideo quadro pci - e series video card.
Well I'm using a 3.0 ghz computer with 1 gig of ram and a nvideo quadro pci - e series video card.