rmoore
2006-10-06, 06:53 PM
When dimensioning a blind hole toleranced with a fit, the tolerance is displayed after the depth. (See attached)
As you can see, what is displaying right now is in this order: Hole Diameter, depth symbol, depth, then fit tolerance. This is confusion our inspection department as they think the tolerance applies to the depth of the hole.
How can I display the dimension in this order: Hole Diameter, tolerance, depth symbol, and finally the depth?
Any help would be greatly appreciated.
BTW, the same thing happens if the hole size is simply toleranced with a standard +/- type of tolerance.
As you can see, what is displaying right now is in this order: Hole Diameter, depth symbol, depth, then fit tolerance. This is confusion our inspection department as they think the tolerance applies to the depth of the hole.
How can I display the dimension in this order: Hole Diameter, tolerance, depth symbol, and finally the depth?
Any help would be greatly appreciated.
BTW, the same thing happens if the hole size is simply toleranced with a standard +/- type of tolerance.