eric.findlater
2004-06-25, 08:22 AM
Hi there
Anyone use MXchange in AutoCAD 2004?
I am working on a network and other network users are not experiencing the same problem. I am importing a MX DPF/DPW from MX Road to AutoCAD. I fill in all the correct paths in the import box eg. MX Drawing, Support Files, AutoCAD Drawing, Drawing Template and in the Folders tab make sure I have the correct .mmd picked, then OK. Page setup is setup to A1 etc...
The drawing appears to be loading up then I get the problem "Unable to create new color palette". I have to hit OK about three times to clear this, then the picture appears on the screen for a few seconds then disappears. In the the nominated directory a drawing has been created but when opened it is empty.
Any ideas?
Anyone use MXchange in AutoCAD 2004?
I am working on a network and other network users are not experiencing the same problem. I am importing a MX DPF/DPW from MX Road to AutoCAD. I fill in all the correct paths in the import box eg. MX Drawing, Support Files, AutoCAD Drawing, Drawing Template and in the Folders tab make sure I have the correct .mmd picked, then OK. Page setup is setup to A1 etc...
The drawing appears to be loading up then I get the problem "Unable to create new color palette". I have to hit OK about three times to clear this, then the picture appears on the screen for a few seconds then disappears. In the the nominated directory a drawing has been created but when opened it is empty.
Any ideas?