OCE 9400 - can't print from Revit

[sbrown]

Ok, I've bashed OCE printers and Revit since the first one I used. Now we have a 9400 and the most I can get out of it is a few grid bubbles. Any ideas. It usually just spits out a blank page.

[Nic M.]

We have a 9300 OCE and if I remember correct it uses the same driver (latest is 3.2 raster driver) as the 9400.
Since this driver we don't have any problem's

Can you give us more details?

[rodneyf]

Scott,
We just got a new TDS600 and everything prints ok except it fills in the "A" in our name. Our representative said that they are looking into it. So since then I have switched over to the HP 1050C driver from HP and all is well.

Hope That Helps,

[jsadams2]

We have a 9600, and we had to go back to the oldest driver we could find on the OCE website (1.4, or 1.8).

[Wes Macaulay]

The OCE printers work well with HP-GL2, and at an old firm I worked at, we printer to it using the HP DesignJet 750C driver, since that was the last printer HP made before they started fiddling with the HP-GL2 format.

We've been able to get output in this fashion, though the linework ends up being a bit light.