View Full Version : Set layer not being saved
2004-06-26, 01:53 PM
After switching to a particular layer and save my drawing, the layer switches to layer 0 everytime I re-open the drawing. Any suggestions to correct this would be appreciated.
2004-06-26, 02:48 PM
Are you running any sort of LISP during start-up
and do you have it set to reload that LISP between drawings?
2009-01-28, 05:10 PM
What happens if you run the "_U" command a few times after the drawing opens?
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.