Duct section visibility

[martinsb21]

I'm working on a HVAC layout in Revit MEP 2008. Through some bungled settings adjustment, the ducts no longer appear in section (when they are perpendicular to the section cut). They do appear in elevation. I've checked the visibility settings, view properties, etc. but can't find anything that would turn off just the section cuts for the ductwork. Anyone else have this problem?

[Emily.Santilli]

BUMP

MEP in my office is having this problem too and I'm searching the forum for probable answers. Anyone else run into this? And better yet, anyone else solved it?

-Emily

[mwiggins121466]

Check what the detail level is set at. This happened to me.

[Emily.Santilli]

Detail level has been verified with no change in the duct visibility...

Anyone else?

[mjdanowski]

I only get that when the detail level is set to coarse, like mwiggins said.

[truevis]

When I get something like that, the first thing I usually try is to Apply View Template of a good view to the naughty view.