PDA

View Full Version : PIPES GET SKEWED????



dpollard909366
2007-07-06, 04:12 PM
I am losing my mind trying to draw piping because everytime I draw a right angle, the pipes skew out of alignment.... Has anyone ever seen anything like this?

I am having trouble understanding the pipe drawing behavior, any advice is greatly appreciated.

Thanks

Steve_Stafford
2007-07-07, 01:04 AM
I have seen this too, I thought I was doing something wrong but after messing around for a bit and getting frustrated too I closed the file and closed Revit. Opened it all back up and it worked properly the first time I tried. Not an answer to why but it worked for me in the past. I suspect Revit was remembering a workplane selection based on something I did previously and wouldn't reset correctly either by using the Spacebar or changing settings.