PDA

View Full Version : Batch plot missing fonts



djohnson.35902
2004-08-05, 06:22 PM
I am trying to create a batch plot. When I run the test it comes back with a bunch of missing font/shape. I have all of the fonts listed as missing. I don't understand why the fonts are not being found. Any ideas will be appreciated.

Glenn Pope
2004-08-05, 08:23 PM
Are the files located in the support file search path?

djohnson.35902
2004-08-05, 08:25 PM
Yes the fonts are in the search path

Mike.Perry
2004-08-05, 08:45 PM
Hi

Check out the following Technical Document on the Autodesk web site under the Knowledge Base section -

ID: TS18798 - Error: Object variable or With Block variable not set (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2892658&linkID=2475323)

As the above Technical Dcoument states; what happens if you actually Batch Plot these drawing files (don't run the Test)?

Have a good one, Mike

djohnson.35902
2004-08-05, 09:09 PM
If I just plot it doesn't work. I don't get the error message that the tech. document specifies

Mike.Perry
2004-08-05, 09:29 PM
Hi

Ok! do these same drawing files Open within AutoCAD without any Error Messages/Warnings (be it CommandLine or Dialog Box)?

Do this drawings Plot without problem from within AutoCAD?

Is it only these drawings files that disply this behaviour within the Batch Plot utility?

Is it possible to post one of these problem drawing files here. Please note, if you do post, I won't be able to look at it until tomorrow morning (8 hours time), but hopefully others will come along and help out in the meantime.

Have a good one, Mike