View Full Version : Curve Driven Pattren In AutoCAD 2004
Deogan
2007-10-15, 04:39 AM
Here You See How Can Do The Curve Through Pattern In AutoCAD 2004
Hope You All Like It!!!!!......
Warm Regards,
Harminder Deogan
checkpost100
2007-11-06, 07:14 PM
Nice,
Is it divide/block or measure/block command?
Filipe Francisco
2007-11-06, 08:42 PM
It's look very nice
Cheers :beer:
claire1027
2007-12-22, 10:41 AM
It is really cool, but how did u make it? :\
Here You See How Can Do The Curve Through Pattern In AutoCAD 2004
Hope You All Like It!!!!!......
Warm Regards,
Harminder Deogan
It is really cool, but how did u make it? :\
It looks like he possibly used a 3D polyline or similar and then used the measure command.
That's just my guess.
Deogan
2008-01-15, 09:25 AM
Great Guess Sir (Opie....)
I Did it with 3D polyline and then use the measure Command
------
Deogan
2008-01-15, 09:27 AM
Nice,
Is it divide/block or measure/block command?
Yes Checkpost
This is Made By Measure/Block Command
Great Guess Sir (Opie....)
I Did it with 3D polyline and then use the measure Command
------
You've done some great modelling in the past. I'm amazed that I was able to figure this one out. I'm usually at a loss as I do very little modelling.
Keep up the good work.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.