civil3d.wishlist1941
2007-12-11, 08:26 PM
Summary: I would like to be able to apply an assembly to a feature line without having to first make an alignment, then a profile, from the feature line.
Description: I would like to be able to apply an assembly to a feature line without having to first make an alignment, then a profile, from the feature line. And I would like to be able to vary which assembly is used from point to point, just like along a simple corridor. This would allow me to quickly apply curb and gutter around a parking lot, for example.
How Used: To design site grading - I use feature lines, but have to offset them to get lip of curb,face of curb, top back of curb, etc. and I have to break them at points where it transitions from reverse pan to regular pan curb.
Feature Affinity: Corridor Modeling
Submitted By: Evon Waters on October 1, 2007
Description: I would like to be able to apply an assembly to a feature line without having to first make an alignment, then a profile, from the feature line. And I would like to be able to vary which assembly is used from point to point, just like along a simple corridor. This would allow me to quickly apply curb and gutter around a parking lot, for example.
How Used: To design site grading - I use feature lines, but have to offset them to get lip of curb,face of curb, top back of curb, etc. and I have to break them at points where it transitions from reverse pan to regular pan curb.
Feature Affinity: Corridor Modeling
Submitted By: Evon Waters on October 1, 2007