View Full Version : Autocad 2008 Mtext Word formate
2007-12-12, 02:41 PM
Creating a single spec sheet from a word doc takes a very long time due to the fact I have to reformat tabns etc.. I copy and paste into mtext. Havent used colums yet. Where can i go to lean the best way of bringing in a word doucment into mtext. A link would be nice but not if i need to OLE. Thanks in advance.
2007-12-12, 05:18 PM
do a ctrl+c on the word doc then open autocad and then start the mtext. In the mtext box do your ctrl+v. this seems to be the easiest I have found. Good luck.
2007-12-12, 08:36 PM
Thanks, However i still loose indents and tabs. Perhaps its the set up in the word document that's throwing me off
Powered by vBulletin® Version 4.1.11 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.