armitage
2008-01-11, 10:46 PM
When adding a wall style from a toolpallette in AutoCad Architecture 2008, the wall style properties are different depending on the drawing that is open at the time. If I use a drawing that was created by our office, the style uses our plotstyles (e.g. thin, thick, etc) but if the drawing is from 2008 the same tool pallette uses different plotstyles (e.g. full saturation, etc.).
The current plotstyle table does not appear to affect this.
Does anyone know what triggers this? Or, how can this be controlled?
The current plotstyle table does not appear to affect this.
Does anyone know what triggers this? Or, how can this be controlled?