PDA

View Full Version : Non-uniform SCALE command for objects



jtdonville
2008-03-03, 01:45 PM
I run into situations where groups of non-block drawing objects are just fine dimensionwise in one axis direction, but I would like to alter the size along just one axis while preserving the other(s).

Is there an existing command that will do this so I don't have to recreate the objects from scratch?

Jeff

H-Angus
2008-03-03, 04:41 PM
I run into situations where groups of non-block drawing objects are just fine dimensionwise in one axis direction, but I would like to alter the size along just one axis while preserving the other(s).

Is there an existing command that will do this so I don't have to recreate the objects from scratch?

Jeff

A workaround would be to convert the objects into a block, scale using the properties palette and then explode the block.