design.74827
2004-09-15, 04:17 PM
I have been running into a recurring problem recently and I think it has only been since I started using 2004. Has anyone Else been running into this error?
I build 3D (solids) models. Once I'm finished with the design I section through the model to generate 2D profiles that I use to lay out 2D drafting plates. Many times I have to explode those profiles so I can adjust them for drafting purposes. I have been using this process for years, however now that I have upgraded to 2004, I periodically crash out of the program when exploding a profile.
The error message:
INTERNAL ERROR: !insert.cpp@3884:eGeneralModelingFailure
it then asks if I want to at temp to save, and recover later. However I keep getting the error each time I try to explode the profile.
I build 3D (solids) models. Once I'm finished with the design I section through the model to generate 2D profiles that I use to lay out 2D drafting plates. Many times I have to explode those profiles so I can adjust them for drafting purposes. I have been using this process for years, however now that I have upgraded to 2004, I periodically crash out of the program when exploding a profile.
The error message:
INTERNAL ERROR: !insert.cpp@3884:eGeneralModelingFailure
it then asks if I want to at temp to save, and recover later. However I keep getting the error each time I try to explode the profile.