jmsiegrist
2008-09-11, 12:47 PM
I'm currently working on a project where the road tapers from 41' to 29'. I have created an assembly for both but cannot get it to show right on the drawing? Please let me know if anyone can be of assistance
Jon Ridinger
2008-09-11, 02:59 PM
You can use target eop/log alignments to describe the taper. Then set the outside width of the pavement subassembly to target the eop alignment.
Depending on medians ect this technique may eliminate the need for multiple assemblies.
JR
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.