CadDog
2008-10-23, 04:42 PM
My history...
Came over from the dark side (MicroStation)
to the light and started woring in AutoCAD in 1992...
Been writing lisp since 1994...
Have created a few VBA programs starting in 2002...
Here is my question which I hope some one around here can help me answer...
2008 Civil 3D "Profile Object"
A couple of users would like to be able to pick an object within a profile and
have that object layer freeze but does happen is that the entire object
(ae Profile) freezes. I have come up with a temp way of doing this but
it is not the best...
The problem I have found is that with Lisp "(nentsel)"
just can't find the lower layer needed to freeze...
Here is a little more on what I try to do under the LISP directory:
http://forums.augi.com/showthread.php?t=88252
I don't have a clue of where else to go for help...
I hope some one can help us...
:)
Came over from the dark side (MicroStation)
to the light and started woring in AutoCAD in 1992...
Been writing lisp since 1994...
Have created a few VBA programs starting in 2002...
Here is my question which I hope some one around here can help me answer...
2008 Civil 3D "Profile Object"
A couple of users would like to be able to pick an object within a profile and
have that object layer freeze but does happen is that the entire object
(ae Profile) freezes. I have come up with a temp way of doing this but
it is not the best...
The problem I have found is that with Lisp "(nentsel)"
just can't find the lower layer needed to freeze...
Here is a little more on what I try to do under the LISP directory:
http://forums.augi.com/showthread.php?t=88252
I don't have a clue of where else to go for help...
I hope some one can help us...
:)