thair
2008-11-04, 02:53 PM
I have a situation where my alignment is 500 ft from the start of my surface data. When creating my section views, the section line obviously doesn't start until around 500 ft but the horizontal axis shows all the way back to 0 ft alignment (all right swath width values). Is there a way to offset the horizontal axis (in view) so that it starts at 500 ft?
p.s. I wish we had more control over our section views (ie: can't set max/min elevation values either). Yes, I have submitted that to C3D wish list.
p.s. I wish we had more control over our section views (ie: can't set max/min elevation values either). Yes, I have submitted that to C3D wish list.