Curved Pipe Not Displaying Correctly

[egmoreno]

I have an instance where a box culvert I am using to represent a COMM duct, at a curved section, is not displaying in model view correctly. In plan view it displays as a curve. Then when switched to 3D Isometric or viewed through Object Viewer it displays as a cube.

Has anybody had anything happen like this?

[brian.hailey933139]

Seems to work just fine for me.
http://i43.tinypic.com/2h7eatv.png

[Dan Elkins]

I've had this exact problem, contacted reseller with no luck. It only seems to happen on rectangular pipes and it seems very picky on the size, some will make the turn some will not.

[brian.hailey933139]

Just a thought, is the radius of the curve less then half the width of the pipe? Perhaps that is the issue.

[Dan Elkins]

That is not the issue for me, most of the pipes have 6-9' radius and the pipe width is 1'-3'. It only seems to happen on rectangular pipes. Attached is a picture of the problem happening for me.

[pschlehr203549]

I was having the same issue and this brought me to your thread. After reading what was posted it occured to me to check the rules.
Change the RULE, and regen. I dont know why, but it solved my issue.

[mjfarrell]

I was having the same issue and this brought me to your thread. After reading what was posted it occured to me to check the rules.
Change the RULE, and regen. I dont know why, but it solved my issue.

Curiousity makes want to ask what part of the RULE(s) did you change that induced the pipes to behave correctly. Not that I've experienced the issue, however others I train and support might run into this along the way.