Re: Rebar Detail Component
I think it's better if you post your detail component family. I'm sure you'll get better feedback that way. Are you using ref. lines to get your rotation to happen correctly? If not, try your hand at that first.
Re: Rebar Detail Component
One of our engineers figured out how to get it to work using a cosign equation to keep the bend constrained and by breaking the rebar into multiple filled regions.
5 Attachment(s)
Re: Rebar Detail Component
Here are the detail components that I created if you don't want to create your own. They are set up similar to the rebar tool in that they will show as a single line for coarse and medium, but show as a double line for a fine view.
As far as the error message I got that as well and the way I over came it was to put and invisible line from the center of the arc to the edge that way it kept the arc anchored in the right spot.
5 Attachment(s)
Re: Rebar Detail Component
Re: Rebar Detail Component
Thanks for sharing djn - much appreciated.
:)
Adam
1 Attachment(s)
Re: Rebar Detail Component
Hey,
Thanks for sharing your reinf bar families. Very much appreciated.
I created another one based on your family - a bar with a hook as a z:ed at one end. We use this one quite a lot at slab steps etc.
Do you know if it is possible to create a bar like this with the 3D bar? I have another post about it here http://forums.augi.com/showthread.php?t=74004
Thanks again
Jonas
Re: Rebar Detail Component
Hard to think after all these years that this has not ended up in Revit yet. Thanks so much for posting this, big help!
Re: Rebar Detail Component
Re: Rebar Detail Component
Thanks a bunch for sharing these. It will make my job soooooo much easier. you are awesome!