I have a stair with 3 risers that is automatically displaying a cutline. Any way to get rid of the cutline? The plan cut plane does not go through this stair--it is all projected.
Thanks
|
I have a stair with 3 risers that is automatically displaying a cutline. Any way to get rid of the cutline? The plan cut plane does not go through this stair--it is all projected.
Thanks
Take a look at your stair with either a section or elevation. Either your cut plane is set low & is cutting the stair, or you have a base offset on the stair, pushing it up into to the default cut line value (4')