Constraints and Parameter in Family

[mr6jam]

I created a Electrical Fixture Family and I am having a bit of difficulty controlling the placement height parameter of the two plates (in elevation) (see attached)

Basically this family has two wall mounted plates that I am trying to control the placement height independently, but its not working because of a constraint conflict. I tried to figure it out but im not getting any where.

Any ideas? Thanks...

[STHRevit]

Hey there mr6jam,

Try this and see if ti is what you are loking for.
Seems to work Ok Now.

I think some of the dims were referencing the ref planes which were not locked to the fitting. I also had to add a dim to the bevel edge to keep it constained to the required width.



Cheers

[mr6jam]

Thank you very much for your time! Works like a charm! I just hope I understand what you did and can do it myself in the future...