Results 1 to 4 of 4

Thread: Trouble snapping to wall core inside corner point

  1. #1
    I could stop if I wanted to Rhythmick's Avatar
    Join Date
    2004-03
    Location
    Colorado
    Posts
    323
    Login to Give a bone
    0

    Default Trouble snapping to wall core inside corner point

    In doing my dimensioning I can't find a way to snap to the inside corner point of the wall core. (I need to do this for non 90 deg wall corners) It will not find the end point or the intersection of the core, it will however find those snaps on the finish wall face. I've tried to start a detail line from that point also with the same results. I'm using 7.0 if that makes a difference. What am I missing?

    Upon further review this only seems to be occuring on intersections vrs corners.
    Last edited by Rhythmick; 2004-11-04 at 05:38 PM.

  2. #2
    I could stop if I wanted to
    Join Date
    2003-11
    Posts
    442
    Login to Give a bone
    0

    Default Re: Trouble snapping to wall core inside corner point

    Check out the last few posts of this thread .

  3. #3
    I could stop if I wanted to Rhythmick's Avatar
    Join Date
    2004-03
    Location
    Colorado
    Posts
    323
    Login to Give a bone
    0

    Default Re: Trouble snapping to wall core inside corner point

    Thanks for the thread, Looks like 7.0 did not address the issue.

  4. #4
    AUGI Addict Joef's Avatar
    Join Date
    2003-12
    Location
    Victoria, BC
    Posts
    1,273
    Login to Give a bone
    0

    Default Re: Trouble snapping to wall core inside corner point

    If you really need to dimension to the core of an angled wall you can detach the wall from its adjacent walls and convert a temp dimension (with the temp dimension set to the core). Then re-attach the walls. (Thanks to Beegee for this one).

Similar Threads

  1. Trouble snapping to face of 3D solid
    By iridium77 in forum AutoCAD 3D (2007 and above)
    Replies: 2
    Last Post: 2010-04-27, 01:04 PM
  2. Replies: 4
    Last Post: 2007-04-08, 12:45 PM
  3. Trouble snapping to the ends of lines??
    By Kiteman48 in forum Revit Architecture - General
    Replies: 1
    Last Post: 2007-02-06, 07:21 PM
  4. Trouble snapping to a line when placing a beam
    By matthew.113087 in forum Revit Structure - General
    Replies: 1
    Last Post: 2006-12-13, 01:20 AM
  5. Dimension to corner point at face of core?
    By wingman in forum Revit Architecture - General
    Replies: 9
    Last Post: 2005-03-08, 03:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •