Metric to Imperial

[..shaner]

Hello.. 2nd question of the day.

I've got an old metric job that i've since switched to imperial. So far everything seems to be switching no problem but i tagged one of my ceilings today and noticed the ceiling height tag is annotating the ceilings in metric still. (the tag is a custom tag i created for our firm)

my project units and the annotation family units are imperial. the label is referencing the "height offset from level" parameter, is there somewhere in my project i need to adjust this to be imperial?

ive attached the family.. but i think the issue is within my project.

Thanks in advance for any help

[..shaner]

screenshot

[cdatechguy]

Its in your family....

Highlight the parameter and then down below you will see a hand pointing at the #....click on that and change to feet and inches, or better yet check the box that says "Use Project Settings"