Hollow Metal Doors and Frames

[cgrover]

Has anyone seen a hollow metal door and frame, where the wall is cut out by the overal width of the door and frame. I find this would be very helpful when working with masonry.

Thanks in advance for your help.

Sincerely,

Grover

[Chad Smith]

You need to edit the sketch lines for the 'Opening Cut' component for the family.
Offset the lines the width of the frame and assign a parameter' (see images).

[Trent Piazzoni]

I believe that there is/was a hollow metal frame family in Rugi. If rugi is going to be up soon. If it's not up tomorrow, I can post it when I get to work tomorrow

Trent

[cgrover]

Thanks Chad and Trent,

I appreciate the help. Trent I'd appreciate if I could download that tomorrow if Rugi is still down. I checked a few minutes ago and it still was.

Thanks,

Chad

[sbrown]

Here ya go.

[sbrown]

with glass, note ones that say alum can be used just like hm.

These are all in rugi so when its available you can get them there.

[sbrown]

this is it for now, if you need a specific type ask, Ive got ones with transoms, sidelites, etc.

[cgrover]

Thanks Scott. I'll check out RUGI again.

grover