Results 1 to 2 of 2

Thread: Array from center equally two directions

  1. #1
    100 Club
    Join Date
    2008-12
    Posts
    175
    0 Did you find this post helpful? Yes

    Default Array from center equally two directions

    While trying out a guardrail block I found if I set the linear parameter to midpoint and added array that the vertical posts would array equally in both directions...

    Learned something new today WooHOOO


    john
    Attached Files Attached Files

  2. #2
    Active Member fkellogg's Avatar
    Join Date
    2005-09
    Location
    West Virginia, via Fayetteville, Arkansas
    Posts
    83
    0 Did you find this post helpful? Yes

    Default Re: Array from center equally two directions

    Can't see your block, cuz I'm on an old system, but I think I did a similar thing with a porch railing block.
    With that, I had two visibilities, one with a picket on center, the other with a space on center, so the end gaps could come out right.
    I also incorporated a wipeout at the pickets, so the pickets would hide whatever was behind them.
    C. Frank Kellogg . . . if you need anything.

    “Nobody loves me but my mother, but she could be jivin’ too.” -- B.B. King

Similar Threads

  1. array in two directions
    By dp.147682 in forum Revit Architecture - Families
    Replies: 7
    Last Post: 2011-07-26, 04:32 AM
  2. Array center, but hold the ends
    By SRBalliet in forum Dynamic Blocks - Technical
    Replies: 9
    Last Post: 2009-02-26, 12:05 PM
  3. Array about center
    By marchitect_nc in forum Dynamic Blocks - Technical
    Replies: 5
    Last Post: 2009-01-05, 04:59 PM
  4. center an array
    By eglover in forum Revit MEP - Families
    Replies: 4
    Last Post: 2008-12-11, 07:54 PM
  5. Two directions array
    By E-Key in forum Revit Architecture - General
    Replies: 6
    Last Post: 2005-11-29, 11:14 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •