Ducts not in section.

[Jrobker]

We cannot see duct on some sections. If we cut another section, elements may appear, but later it will not show others.
1. creating a new section does not work.
2. redrawing the duct does not work.

Has anyone experienced this issue?

What does the message about containing more than 50 elements and revit will no longer update sections? May this have something to do with it?

[JoelLondenberg]

Is the section straight or has it been split? We've seen that split sections just don't work with MEP elements. If that's not it, then make sure the duct knows what type of system it belongs to, that way it can show the section symbol. Also, you need to set the view to fine detail.

Whenever things don't show there are 3 things to check... Visibility Graphics-Filters-Worksets. Double check these settings in which ever view is acting up.

[Jrobker]

We figured it out. It was a new machine and our crack "IT" department didn't install the SP's. They're installed and everything looks good.

Thanks