hello all,
i had installed Robot professional 2011 x64, it ran ok. today the program present some bugs and i unistalled. then i used my disk to install Robot professional 2011 32bits. it seems all ok. when i openned a robot file (it was resent file, delivered project) i wanted to run but i found after i ran today that robot does not recognize shells (walls and slabs) it has an error (Not Material) and then i found that the meshing option changed too. now it does not allow to have the advance tool.
few hours ago i unistalled (i used REVO UNINSTALLER) to remove all, included Registry. i went to RegEdit too. then i reinstalled again, now x64 version. and gave me the same problem.
what can be wrong now???
do i missed some steps?
i am attaching 4 photos
fig1 everything seems OK
fig2 you can see shells, mesh, openings
fig4 we do again the calculation. then all changes
fig5 we can see now the shell does not have thickness. i tried to give, but the program did not allowed.
regards