Slab Sloping Stumper

[stephendenton]

Hi all, new to the forum,

I'm modeling the shaping on the bottom of a bio-solids storage facility my companies about to build; the top slopes downward to a sump, offset to the side in the slab. It sets on top of a foundation raft slab. I can set the slope points and split lines to get the top of the shaping slab just fine, the bottom however must be flat and level. That means the shaping slab must start out at 1'3" and taper down to 3" at the sump. I could produce this in standard autocad and import it fairly easily, but I'm looking to do this project all in revit to maintain functionality and consistency. Any tips or tricks would be appreciated (forum search came up dry).

Thanks,
Stephen

[Andre Carvalho]

If you go to the properties of your slab, you can set the thickness of the layers to be variable or not which will make the bottom flat or not.

Andre Carvalho