I can have multiple annotative locations of text in a drawing, so that in different scale viewports, the text is not only shown at the correct scale, but can be in different locations to have it fit best at that specific scale. This same ability does not seem to be available for duct label curves - anyone been able to figure this out?

For example, I have a duct that at 1/8'' scale wants to have the label be at the center of the duct - but at 1/16'' scale, the text is too large to fit in the duct, so I would like to move it to be above the duct (but still keep it at the center for the 1/8'' scale).

-Buzz