I've set the XRef to 100' since most of the building I'm working on has most of the first floor at that elevation. This helps when I query a point using ID Point against what's shown on the Contract Drawings without having to break out the calculator. One thing I've noticed is when I use either Aligned or Rotated Dimension and snap to a point on the XRef or anything else that's been elevated to near 100'. The end grips of the Dim are at 100' but the text and extension lines are at 0 ft. Kind of a pain when I start panning around and can't see the dim since it's 100' below my view. Is there a setting I don't know about that would remedy this problem? I've also set the Base 'Z' Elevation to 100' and have the "Make new dims associative" checked but this doesn't solve the problem. Thanks in advance.