transition rectangular(flange) to round(slip joint)

[Macieto]

hello,

I was thinking that it will be a small problem but i was wrong......

Is there any part in MEP like transition rectangular(flange) to round(slip joint) (take a look at the attachment or visit the link to know what i meant)
http://www.spiralmfg.com/transf.htm

Or maybe there is any other way to do i proper. I mean situation like this:
I'm drawing the rectangular duct 300x300 (flange of cours) and then i want to change shape to round DN200 (slip joint) - how You do it to have proper connection types?

[stykface]

hello,

I was thinking that it will be a small problem but i was wrong......

Is there any part in MEP like transition rectangular(flange) to round(slip joint) (take a look at the attachment or visit the link to know what i meant)
http://www.spiralmfg.com/transf.htm

Or maybe there is any other way to do i proper. I mean situation like this:
I'm drawing the rectangular duct 300x300 (flange of cours) and then i want to change shape to round DN200 (slip joint) - how You do it to have proper connection types?

I don't think you can have the sq. to rnd. fitting have two different connector types, but just enable flanges for rectangular duct only and not for round duct and the flange will only show on the rectangular side of the fitting. The 2nd connector of the continuing round duct you can set it back to slip joint and keep routing.

[Macieto]

I don't think you can have the sq. to rnd. fitting have two different connector types, but just enable flanges for rectangular duct only and not for round duct and the flange will only show on the rectangular side of the fitting. The 2nd connector of the continuing round duct you can set it back to slip joint and keep routing.

ok, so I was thinking unfortunatelly.....
thanks stykface