Express Tool Flatten
We had some issues with a couple of our drawings recently where somone was working in 3d for practice and saved the drawings to our masters. Of course as you would guess this caused issues. I ran the flatten command from the express tools. This worked for what I needed however afterwards I noticed that it creates "flat" blocks in the block definition list. Now I wanted flattened blocks however I did not want multiple occurances of a block to be created in the listing.
My question is this: Is their anyway to either set the flatten up to overwrite the current block definition with the flattened block? Or is there any way to only have just one occurance of the flattend block definition? I do not want to have to go in and now clean out all of these blocks each time we run this command.
Thanks,
Bill
Reply With Quote
