Results 1 to 2 of 2

Thread: Help adding a rounded edge to a mass

  1. #1
    Active Member
    Join Date
    2008-08
    Location
    Auckland New Zealand
    Posts
    52
    Login to Give a bone
    0

    Default Help adding a rounded edge to a mass

    I would like to add a rounded edge to a L shaded mass to make a kitchen bench top. Just wondering if any1 knows how i go about doing this?

  2. #2
    All AUGI, all the time Elmo's Avatar
    Join Date
    2005-04
    Location
    South Africa
    Posts
    959
    Login to Give a bone
    0

    Default Re: Help adding a rounded edge to a mass

    2 methods come to mind really. Althoug first thing I would do is not make a mass but a casement family.

    Anyways, you could either shorten the edges slightly and then apply a sweep with a rounded edge and then join geometry. Or you could use a void with a sweep with the inverse of what the sweep would have done.

    I would recommend the first solution as it is easier to setup and a lot less hassles than the void would give you.

Similar Threads

  1. Flip Edge Direction of "Add Edge" in Conceptual Mass
    By Wish List System in forum Revit Architecture - Wish List
    Replies: 0
    Last Post: 2012-11-14, 01:55 AM
  2. Conceptual Mass Edge Line???
    By thand in forum Revit Architecture - General
    Replies: 3
    Last Post: 2010-10-21, 08:20 PM
  3. Add Edge to top face of a Mass
    By Bryan Thatcher in forum Revit Architecture - General
    Replies: 0
    Last Post: 2010-08-19, 03:44 PM
  4. Edge Trimming In Conceptual Mass Editing Mode
    By courtlandtgross in forum Revit Architecture - Families
    Replies: 0
    Last Post: 2009-10-01, 08:47 PM
  5. Concrete beam with rounded edge
    By JH75 in forum Revit Structure - Families
    Replies: 2
    Last Post: 2008-11-26, 02:09 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •