Revit Link not appearing in section

[ckeelor]

Has anyone come across this issue where a Revit Link is clearly within the extents of a section cut, but does not display? Further, sometimes it can be "tricked" in to displaying by changing the extents, or far clip offset.

I have linked a Revit Architectural 2011 model into my Revit Structural 2011 model and I seem to get this problem sporadically. I am using the same view template for views that work and views that dont work.

Any help would be appreciated.

[jcoe]

Did you by any chance change the discipline setting of the view? I know this changes the display of a regular model, but am not sure if it works on links.

[Scott Womack]

Check the Depth Clipping ; it needs to be set to No clip or Clip without a line. Setting it to Clip to Line seems to cause the wierd behavior in 2011.

[ckeelor]

Scott, that did it! thanks so much.

Oh, and i wish i could be working back in Pittsburgh!

[aargumaniz]

I know that this is an old post but I'm having the same issue or/and worse. I did change my plan view to Structural discipline while working in Revit Architecture. Why you ask, well I didn't want these new sections to appear in my working floor plan. These sections are created to export to our folk using Microstation.

When I would open the sections while in the Structural discipline I noticed that even though my section was looking East, I was able to see all the information on the West side of my plan. I later figured out that it was the Structural Discipline that was creating this error. I changed my floor plan view back to Architectrural but the sections were still wrong, and some of the sections were missing a big chunk of the building that is attached to the file that I am creating the sections from.

I've purge and audited the file and I can't fix this. This project is also a workshared project.

Any solutions before I submit this via subscription?