Results 1 to 4 of 4

Thread: Cladding

  1. #1
    Member
    Join Date
    2009-09
    Location
    Riga, Latvia
    Posts
    26
    Login to Give a bone
    0

    Default Cladding

    Hello!
    I have some kind of frame. Binding cladding around the perimeter, and note the direction along the Y axis. After calculating the load is transferred to the cross wind bracing. Is it possible to put pressure so that the wind would not take into action the bracing?!

    Thanks
    Attached Images Attached Images

  2. #2
    Member
    Join Date
    2010-01
    Location
    Greece
    Posts
    47
    Login to Give a bone
    0

    Default Re: Cladding

    After analysis go to geometry->additional attributes->load distribution options, select the bracing bars and press ignore. You can see how the loads have been distributed by pressing display->loads->forces generated and load distribution regions.

  3. #3
    Member
    Join Date
    2009-09
    Location
    Riga, Latvia
    Posts
    26
    Login to Give a bone
    0

    Default Re: Cladding

    Its working!!! Thanks!!

  4. #4
    Login to Give a bone
    0

    Default Re: Cladding

    I have a problem with the load distribution via claddings. Although it is working properly and the load is being distributed correctly the load distribution regions don't display correctly. In fact in rsapro 2010 this problem doesn't exist. It only exists in 2011. Anyone else has the same problem?

Similar Threads

  1. 2014: curved cladding panel
    By jagostinho in forum Revit Architecture - Families
    Replies: 4
    Last Post: 2014-12-15, 03:38 PM
  2. Cladding Properties
    By dcooper.cse in forum Robot Structural Analysis
    Replies: 9
    Last Post: 2010-04-27, 01:34 PM
  3. Profiled sheet roof cladding
    By septerverius in forum Revit Architecture - General
    Replies: 5
    Last Post: 2009-09-09, 03:35 PM
  4. Weatherboard cladding
    By rorypsco in forum Revit Architecture - General
    Replies: 2
    Last Post: 2009-05-28, 11:56 AM
  5. corrugated metal cladding
    By Justin Marchiel in forum Revit Architecture - General
    Replies: 4
    Last Post: 2005-12-08, 12:17 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •