Linear Releases

[scott.260040]

I am tryin to assign linear releases to a panel.

Is it possible to assign linear releases to a single panel supported on bar elements? I want the panel to be simply supported between the bars without inducing torsional forces with these bars.

Many Thanks

Scott

[length zero]

Yes this work in proper wat,
You can release bars if u want , and panel if u want

[scott.260040]

@length zero,

Thankyou for your response. But I'm afraid I don't understand. I don't know how to apply the releases to the panel. Can you give me any pointers?

[length zero]

Yes
At geometry meny - Additional attributes - linear release,
And yo can fix or free: ux, uy, uz, rx in local axis of panels
By deffault is added an release - pin which is released rotation about edge fo panel - RX
Hope it help

Regards
Z.G.

[troy_the.best]

hi Z.G.

i have a problem. I hope you can help me this case.please look in attached picture. thanks in advice.

falconado_turkey
A.S.C.

[troy_the.best]

Hi Z.G.

this is my project. please look this. thanks.

[length zero]

Troy
If you are talking for releases, you dont need to apply point supports.
You must define linear release.
I check your model but i dont know what are interested to check
Regards

[troy_the.best]

Troy
If you are talking for releases, you dont need to apply point supports.
You must define linear release.
I check your model but i dont know what are interested to check
Regards

I understood you. but it seems as though the screen supports. it was not any releases. but it seems support. and then during analysis automeshing shell this nodes assign itself support (base). its possible? or is this a bug??

best regards
falconado_turkey
ASC

[length zero]

i dont thing so,
I dont thing that program assign automaticly supports, hahaha
Maybe you have done accidentally,

[troy_the.best]

i dont thing so,
I dont thing that program assign automaticly supports, hahaha
Maybe you have done accidentally,

"it s ture" ZG. i dont belive that. i m confuised.

i was send my model. please review and analysis please. then we write again. Thanks in advice!

best regards
ASC