Is there a way to show a dash instead of a space in the pipe size? (2-1/2" instead of 2 1/2")
I tried looking in the project units but there does not seem to be an option to add the dash...
Thanks!
|
|
|
Is there a way to show a dash instead of a space in the pipe size? (2-1/2" instead of 2 1/2")
I tried looking in the project units but there does not seem to be an option to add the dash...
Thanks!
I haven't seen that done in Revit. I checked under the "Mechanical Settings" - "Pipe Settings", but don't see that option there either. I tried defining a new pipe size as 2-1/2", but it gave me 24 1/2".
Good luck.