|
|
_pedit joining lines
I have a single line for a pipe line in 3D that I want to turn into a continuous polyline. But some corners will not select. Message I get is "The object is not parallel to the UCS." I have the UCS moved to the corner I am working on and in the the x,y plane.
Re: _pedit joining lines
Hi
Can you post a simple example drawing file (.DWG) should we could take a look.
+
Might want to have a browse the following thread -
Filleting Polylines in 3D???
Have a good one, Mike
Re: _pedit joining lines
The easiest answer I've found is to create all the various lines then use "3dpoly" to create a new pline (using ENDpoint osnap) over the existing ones.
Re: _pedit joining lines
Thanks Guys I was using the 2D poly line edit. It worked fine with 3Dpoly
Merry Christmas
mark
Posting Permissions
Reply With Quote