Service Pack 4 for Autodesk Robot Structural Analysis Professional 2011

[Tomasz.Fudala]

The Service Pack 4 for Autodesk Robot Structural Analysis 2011, and Autodesk Robot Structural Analysis Professional 2011 (32 and 64 bit) has been published.

It is available via LiveUpdate and the Product Page: http://usa.autodesk.com/adsk/servlet...inkID=13140816

[matti.pitkanen]

Hello,
Installation does'n work here: message and information of my present situation
are in attached pictures.

BR Matti

[per.hedmark]

I have the same problem

/Per

[per.hedmark]

I solved the problem.

I took the wrong version, used "Autodesk Robot Structural Analysis" insted of
"Autodesk Robot Structural Analysis Professional 2011"

/per

[Tomasz.Fudala]

Exactly, be careful with that. There are 3 new updates on this page:

Autodesk Robot Structural Analysis 2011 Update 4
http://usa.autodesk.com/adsk/servlet...inkID=13140816


Autodesk Robot Structural Analysis Professional 2011 Update 4
http://usa.autodesk.com/adsk/servlet...inkID=13140816


Autodesk Robot Structural Analysis Professional 2011 (x64) Update
http://usa.autodesk.com/adsk/servlet...inkID=13140816

[mj_lampad@yahoo.com]

just like SP3 I cannot install SP4 to update my RSA 2011

[Marios]

Try through the communication center inside robot. That always works for me.

[beisoplus]

Hi, I've installed service pack 6 and now, it takes long time to calculate concrete beam reinforcement during dimensionning, It takes at least 30mn for one beam. What is the solution? excuse me for my bad english.

[szaky007333406]

i've also tried the update and it makes robot run sooo slow, and calculations that other time took like 10 sec now take 1 min...:-< lucky i used system restore to bring back old version