I am looking for a 45º rectangular duct tap/takeoff. Does anyone out there know where I can find one, or would be willing to share one they've got perhaps? Thanks in advance!
|
I am looking for a 45º rectangular duct tap/takeoff. Does anyone out there know where I can find one, or would be willing to share one they've got perhaps? Thanks in advance!
Can't you just use the Justify tool to align the new duct with the Middle Left/Right side of the main duct? Are you trying to go from rectagular to round? I have found this to be a bit more difficult.
Does anyone else have input on using the Justify tool to get from a rectagular main to a smaller round duct?
Chris
Swartzie,
Attached is one I have been using. I forgot where it came from, somewhere from this site I believe.
Bob