Results 1 to 3 of 3

Thread: Duct size tag

  1. #1
    Member
    Join Date
    2012-08
    Posts
    23
    Login to Give a bone
    0

    Default Duct size tag

    I'm trying to create a duct size tag that includes the duct dimensions without inch marks, which show in the default tag. The Size parameter in the label of the Duct Size tag includes an inch mark. Any advice on how to create a parameter that reads and reports the duct dimensions, but leaves out the inch marks?

  2. #2
    I could stop if I wanted to
    Join Date
    2004-06
    Location
    Port Moody, BC
    Posts
    349
    Login to Give a bone
    0

    Default Re: Duct size tag

    You shoudl change it to using Width and Height instead of size, then you can modify the format for the parameters. the attached image shows some settings that get what you are asking for

  3. #3
    Member
    Join Date
    2012-08
    Posts
    23
    Login to Give a bone
    0

    Default Re: Duct size tag

    I followed the directions you mapped out in your illustration, and the tag works well! Thanks for your help. I use the same tag for round duct, and I left the inch mark associated with the diameter dimension. I'm sure knowing how to edit a label will be useful in the future. Go Canucks!

Similar Threads

  1. 2014: Duct size inch marks remove from duct size tag
    By rbelfiore337841 in forum Revit MEP - General
    Replies: 3
    Last Post: 2014-10-24, 02:28 PM
  2. Replies: 5
    Last Post: 2013-08-14, 02:28 PM
  3. Duct Size Units
    By rbelfiore337841 in forum Revit MEP - General
    Replies: 6
    Last Post: 2012-09-18, 08:59 PM
  4. AMEP 09 Duct Size Help
    By ReachAndre in forum AutoLISP
    Replies: 5
    Last Post: 2010-08-25, 03:24 PM
  5. duct size above 1000
    By Beancud in forum Revit MEP - General
    Replies: 4
    Last Post: 2009-11-16, 07:05 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •