Corridor & Prop Surface

[kolk]

I'm having an issue with a proposed surface seeming to ignore part of my corridor. This is happening just prior to an intersection. Everything else seems pretty normal, so I guess I'm out of ideas.

Any thoughts?

I'm running Civil 2011 64-bit on Win 7

Thanks!

[cxyuksel571806]

Hi,
Your Profile might shorter than alignment.

[tonycarcamo]

sometimes if you create a dynamic corridor boundray and there is a small gap between corridor sections, than the corridor surface will not build correctly. Check to make sure all sections begin and end at the correct locations. Second, if you used the stretch option on one of the corridor sections, sometimes it will ignore that surface section. I never use the stretch corridor section because it doesnt work all the time. I just go ahead and build that region. Post a image or email me an image if you like.

tony
senior design tech
www.tonyscivil3dworld.blogspot.com