UV Grid by Intersection and Nodes at the edges

[pfaudler]

Hello,

I am generating a UV grid by intersect in mass in order to populate surface with adaptive family. It works fine except border panels. Typical panel is rectangular in nature and border panels are trapezoidal. But my problem is placing trapezoidal panels on border because i don't get nodes on the border so I can't select points to place adaptive family manually.

Any idea how to get adaptive points on border?

Please see attached image and revit file. I dont't get nodes at the fold of two non-planner surfaces.

Thansk in anticipation.

[hadlari]

Hey,

Place points hosted along your border reference line and then host the points by intersection by the UV planes used to divide the surface.

Hope this helps

Regards,

M