I have using the structural detailing for my first time for work on a new school building (80x80).
done my pile caps and have grouped the rebar into each different pile cap ie 2 pile cap, 3 pile cap etc. using element manager, and have told them the quantity of elements ie 10No 2 pile caps.
but if you have the same rebar in different elements the table leaves a blank in the number of elements, is there any way around this can you manual type this in.
and on my 3 pile cap group I have diminishing bars again on the table it give an average length, can it do all the different bar lengths separate instead of average.