ok, just a shout out for some help here. I need a little help on a sidewalk project that we have in our office. the sidewalk itself isn't such a big deal. i have my assembly built, my alignment along the connection point, in this case the existing back of curb and my corridor is working fine. the problem i am running into is when i do a driveway connection. i have a pdf attached to this message and hopefully it can explain things a little bit better than i can. Hey, a picture is worth a 1000 words right? i am thinking i will need another assembly or i can probably just do it with feature lines, but i'm not 100% sure on this. if anybody knows of a to do this or can point me to some sort of documentation or instruction, the help would be most appreciated