Flat Oval duct Profile missing

[mrypdahl]

Hello,

I upgraded our Revit MEP company template file from 2010 to 2011 and the flat oval duct profile is not available. I tried but, is there a way to load the profile in or do I need to start a new template file from scratch?

Thanks,

[drewj]

Open up a new project based on the default 2011 Mech template, then go back to your template and use the Transfer project standards, select the Duct Types only.

WHen transfering, select New Only so that you dont overwrite any changes you made to round and rectangular duct types.