I want to design post tension beam and slab.
It seem that RSA 2011 does not have anything for them.
|
|
RSA 2011 can do RC post tension design ?
I want to design post tension beam and slab.
It seem that RSA 2011 does not have anything for them.
Re: RSA 2011 can do RC post tension design ?
Yes, try to look Adapt or Safe by CSI.
Re: RSA 2011 can do RC post tension design ?
Yes you can, but this is basically a hand-crafted approach.
You can use the tension-only cable elements and employ compatibility nodes to fit the tendons into structural shells.
You will encounter a huge amount of toil, sweat and tears though, because of certain peculiarities of Robot (like FE stickyness) and because, well, Autodesk is disinterested with Robot to the point where it doesn't know where their own forum for Robot is: http://twitter.com/#!/autodesk/status/69013626203291648
Re: RSA 2011 can do RC post tension design ?
Roman,
How an I have a look Adapt or Safe by CSI ?
Is it another software to intergrate with Robot ?
Re: RSA 2011 can do RC post tension design ?
tngv,
You can read about Adapt at this point and about Safe at this point.
Posting Permissions
Reply With Quote