|
|
Generic model line weight BOLD problem
I have a unique balaster that I have made out of a face based generic mode. The problem is that no matter what view in the model the dang thing is BOLD. I cannot get the linework to go to anything else.
Graphic overrides, by element won't even work.
Any ideas?
Re: Generic model line weight BOLD problem
Assign the baluster its own name under Generic Models....then reload it into all the parent files. If that doesn't work you may have to use Filter and find by family name.
You can always post the baluster as well...
Michael "MP" Patrick
"I only drink :coffee: until it's acceptable to drink :beer: or :whiskey: or :wine:"
Re: Generic model line weight BOLD problem
The section views looked great so I just created a view template and applied it to the interiorior elevations.
Sometimes instead of trying to figure out why it is faster to fine a work around.
I will keep the tip on the naming generic family on the back burner.
I was just told that this project is now handed off from our DD phase to the partnering firm for CDs. I don't have allotted time to work on it now but I may putter around with it on my own time.
Posting Permissions
Reply With Quote