Hello all,

I can’t seem to get the GPM to calculate down my hydronic pipe system and am looking for some help.

I have created a new family for my baseboard heaters from the generic template, and was sure to keep the flow units the same in the family and the model. I can connect my pipes to the new component and it does recognize it as a system, however, it does NOT calculate the GPM once connected.

I’ve triple checked my pipe connector directions, system type and flow units, and I still don’t know what’s going on. I have tried to assign a flow (GPM) to each pipe connector and also tried creating a new parameter within the family for flow and neither method works.

If anyone could tell me if there’s something I am missing or any other tips to help It would be so great.
-Thanks