Is there any way to change how the family references the elevation parameter in the wall-hosted families? It defaults to the bottom of the elements, but I want it to reference to the top of the sink. See attached screen-shot.
|
Is there any way to change how the family references the elevation parameter in the wall-hosted families? It defaults to the bottom of the elements, but I want it to reference to the top of the sink. See attached screen-shot.
Isnt it just a case of within the family editor ensuring that the sink is positioned in the right place?
ie: the top of the sink is on the "Ref Level"
I've repositioned the sink so that the top of the sink was at reference level. The workplane for the top of the sink was already set to ref level, but I re-set in anyways to make sure. There was no change, the family still references to the bottom of the sink for its elevation.
Any other ideas? Thx!